Material Dealing with Power UNIT one
This power unit is developed for your fork lift sector, consisting of really productive gear pump, DC motor, manual raise and lower valve, tank, ect. The up and down movement are managed through the lever on the manual release valve, which is equipped with an electric switch to activate the motor. The lowing speed is managed through the pressure compensated flow management valve.
1. The duty of this power unit is S3, i.e. 30 seconds on and 270 senconds off.
two. Clean each of the hydraulic parts concerned just before set up of the power unit.
three. Viscosity in the hydraulic oil shoud be 15~46 cst, which ought to also be clean and no cost of impurities, N46 hydraulic oil is suggested .
4. Oil changing is required just after the original one hundred operation hrs, afterwards the moment each 3000 hrs.
5. The electrical power unit shown is made to be mounted horizontally.
Materials Managing Power UNIT 2
This energy unit attributes electrical power up gravity down circuit. Activate the begin solenoid to start the motor to lift the machine. The lowing motion is activated from the solenoid valve with all the reducing pace controlled from the strain compensated movement management valve. Solutions of this series could be broadly used in the industry of logistic devices like fork lift, mini lift table, and so on.
1. The duty of this power unit is S3,i.e.,30 seconds on and 270 senconds off.
two. Clean each of the hydraulic parts concerned before mounting the electrical power unit.
3. Viscosity from the hydraulic oil shoud be 15~46 cst,which must also be clean and totally free of impurities, N46 hydraulic oil is proposed .
4. Oil changing is needed after the first one hundred operation hrs,afterwards as soon as every single 3000 hrs.
five. The electrical power unit should be mounted horizontally.