Energy UNITS FOR LIFT TABLE

Electrical power UNITS FOR LIFT TABLE one
Standard Description
This power unit is built exclusively for that little lift table,Consisting of higher pressure gear pump, AC motor, multi-functional manifold, valves, tank, and so on. This electrical power unit has been widely utilized inside the field of logistic products including minifork lift, scissors lift and ariel operating platforms. The lower-ing movement is controlled from the solenoid valve with all the pace controlled through the adjustable needle valve.
Electrical power UNITS FOR LIFT TABLE two
General Description
This electrical power unit is built exclusively for your medium lift table, Consisting of really effecient gear pump, AC motor, multifunctional manifold, valves, tank, ect. The decreasing movement is actived through the solenoid valve and the velocity controlled through the adjustable needle valve. When the lift rises to a higher positoin, but the electrical power supply is cut, the decreasing movement is controlled by the manual override perform.
Electrical power UNITS FOR LIFT TABLE 3
Common Description
This electrical power unit is developed solely for the substantial lift table, Consisting of highly effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The lowering movement is actived through the solenoid valve as well as speed controlled by a stress compensated flow handle valve.
Energy UNITS FOR LIFT TABLE four
Standard Description
This power unit is designed solely to the substantial lift table, Consisting of extremely effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The decreasing movement is actived through the solenoid valve and also the pace managed through the adjustable needle valve. Once the lift rises to a higher positoin, but the power supply is reduce, the reducing movement is managed by the guide override function.
Distinctive Notes
1. This power unit is of S3 duty cycle, which may only work intermittently and repeatedly, i.e. one minute on and 9 minutes off.
2. Clean every one of the hydraulic elements concerned just before installation of the energy unit.
3. Viscosity from the oil shoud be 15~46 cst,which must also be clean and absolutely free of impurities.N46 hydraulic oil is advised.
4. Oil changing is needed right after the original 100 operation hours,afterwards the moment each 3000 hours.
5. The energy unit shown is made to be mounted vertically.

Tags:

Recent Posts

Gearboxes worm

As one of leading Gearboxes worm manufacturers, suppliers and exporters of mechanical products, We offer gearboxes worm and many other products.

Please contact us for details.

Mail: [email protected]

Manufacturer supplier exporter of gearboxe worm.